CMP file is nothing other than LZSS compressed data. Likely can take the raw uncompressed firmware file from the update and add it into the end of it. This should at least replicate what's in memory. I took the binary image from the 28f800 and did the following to make an image that can be flashed to the station with the OUTLAW program. I'm not 100% sure on this, but I belive the firmware is locked to the base station from motorola using the.

To unlock a locked MTR2000 just temporarily until next power cycle you can use the following commands via the serial port:.

write down your backplane ID number (you can also see it in RSS as station ID).

Send commands (you´ll see nothing during input!):.

With a serial terminal connect at 9600 8N1 to your MTR2000.

Download the codeplug and save it! Take screenshots of every alignment data as well.

Use Windows XP 32 bit with a real serial port or FTDI based USB port.

Manuscript by Chris, DG2NGI to change Station ID of Motorola MTR2000 for firmware upgrade via RSS This procedure was developed by Chris, DG2NGI and formatted for the wiki. This uses an Arduino Uno to emulate the 1 wire serial ID of the DS4201. What does work is emulating the DS2401 to change the ID during programing via RSS to a known supported license key enabled upgrade. A workaround using the OUTLAW depot software may be possible be I have not verified it.

ocr30403.enc, individual file needed to identify Serial number in Dallas DS4201 U101 on backplane)Īs of now there is no known universal upgrade file for the MTR2000 as there is with the Quantar. Mtr2000-OCR30403 cmp file for uploader to upgradeĪrduino Uno DS2401 Emulator for Station ID 8F11111C FirmwareĮvery MTR2000 has an individual firmware package from Motorola much like the Quantar. MTR2000 Firmware R03.04.03 for station ID 8F11111C - LATEST FIRMWARE 4.5 MTR2000 VHF R2 High Power Amplifier.4.4 MTR2000 VHF R1/R2 Low Power Amplifier.2.1 Procedure to update via DS4201 emulation.

Motorola mcs2000 program for repeater